How do I reset my 2960x password?
Cisco 2960x Password Recovery Procedure
- STEP 1: Hold Down the Mode Button on the front of the switch.
- STEP 2: Power up the Switch whilst keeping the mode button held in.
- STEP 3: Let the mode button go at the right time and then enter a few commands.
- flash_init.
- dir flash:
- boot.
How do I reset my Cisco password without losing the configuration?
Reboot the router using the power switch. Press BREAK on the console terminal. When rommon>1 appears on the screen enter confreg 0x2142 comand to restart from the flash (This step skips the start-up configuration where the passwords are stored). Enter the RESET command when rommon2 > appears on the display.
What is the default password for Cisco 2960 switch?
cisco
When prompted, enter the default password, cisco.
How do I reset my Cisco 2950 password?
Step-by-Step Procedure
- Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.
- Unplug the power cable.
- Power the switch and bring it to the switch: prompt:
- Issue the flash_init command.
- Issue the load_helper command.
- Issue the dir flash: command.
How do I reset my cisco 2950 to factory settings?
If indeed the switch has a MODE button on the front panel, Step 1: turn off/on the switch while holding the button down for roughly 15 seconds. Step 2: You will be able to view the led lights blink, and now the switch should have reset to default on system restart once you release the mode button.
How to reset your Cisco 2960 switch password?
With many cisco switch user have this problem for a long time. This article is in order to help them solve this problem with an easy method. Easy way to reset Cisco 2960 switch password: First, power off your Cisco 2960 switch by unplugging its cord. As you reconnect the switch to the power source, press and hold the “Mode” button.
How to reset Cisco 2960 to factory default?
– To verify the VLAN information, issue the show vlan command, and to verify the vlan.dat file, issue the dir command. – Delete the VLAN information from Flash or NVRAM, and reload the switch. – After reload, check the VLAN information with the show vlan command. The user-configured VLANs no longer appear in the command output.
The documentation provided by Cisco states that the default password is simply cisco and that a username is unnecessary. Needless to say, it doesn’t work. I’ve also Googled for other default passwords (such as cisco-cisco as the username-password), none of which worked either.
How I can reset port in catalyst 2960?
The udld reset privileged EXEC command to reset all interfaces shut down by UDLD